Ardex DPM 1 C Damp Proof Membrane One Coat

In stock |

<ul> <li>Protects the final floorcovering from residual construction moisture and rising damp</li> <li>Can be applied where a structural damp proof membrane is not present or is ineffective</li> <li>Suitable for use on surfaces with the highest measurable levels of moisture content (up to 98% RH)</li> <li>Suitable for use on Anhydrite/Calcium Sulphate based screeds</li> <li>Adheres to saturated concrete even at lower temperatures</li> <li>Can receive ARDEX Smoothing and Levelling Compounds in as little as 6 hours</li> <li>Suitable for use on cement/sand screeds containing water based under floor heating systems</li> <li>Apply ARDITEX NA direct without priming</li> </ul>

Product Options:

Description

Ardex DPM 1 C Damp Proof Membrane One Coat Damp Proof Membrane and Residual Moisture Suppressant

  • Guarantees the early laying of all floorcoverings
  • Walkable in 6 hours
  • Accommodates Hygrometer readings up to 98% RH in one coat
  • Adheres well to wet concrete even at 10°C
  • Suitable for cement/sand screeds containing underfloor heating systems

Apply ARDEX DPM 1 C to protect the floorcovering installation from residual construction moisture and ground bearing moisture. Ideal for use where there is no functioning structural DPM (common in older properties).

ARDEX DPM 1 C is a one coat solvent free, low viscosity, two component epoxy resin. After hardening, ARDEX DPM 1 C produces a membrane which can accommodate hygrometer readings up to 98% with high inherent bond strength. ARDEX DPM 1 C has excellent resistance to water, grease, oil, aqueous salt solution and dilute mineral and organic acids.

Density at 20°C: 1.54

Working Time: 20 minutes at 20°C

Over Coating if required: 6-8 hours at 20°C

Walkability at 20°C: After 6 hours

APPLICATION
Apply an even coat of the mixed ARDEX DPM 1 C with a suitable V shaped notched trowel over the appropriate area, see table below. Whilst the ARDEX DPM 1 C is still wet, the serration ridges should be flattened out with a long handled short pile paint roller, initially pre-wetted with the mixed ARDEX DPM 1 C.

The applied film thickness can be checked with wet film thickness gauge. It is essential that the applied ARDEX DPM 1 C is a continuous film and free from pinholes, cavities or thin patches, which can occur on porous screeds for example, in this case an additional application, may be necessary. 

Evenly spread the mixed unit over one of the following approximate areas, dependent on the surface texture and thickness required:

 

More Information

Brand Ardex
Colour Black
Coverage Refer attached technical datasheet
Type Damp Proofing

Technical Info

Reviews

Product Questions